• DamZ
  • New member
  • Offline
  • Registered: 2009-06-19
  • Posts: 2

Topic: Spectrum analyzer input

Hi guys. I'ive got a FF400 on OSX 10.6 with latest firmware, drivers and digicheck version. I dont reach to get signal in spectrum analyzer and totalyzer: i had a problem on my m and i dont remember the settings.
i notice that in level meter i have got output listen on hardware level, on spectrum and totalyzer dont.
do i have to route in a particolar way to get in it?

thanks

damz

2 Reply by ye

  • ye
  • ADAT user
  • Offline
  • Registered: 2010-01-06
  • Posts: 31

Re: Spectrum analyzer input

I thourght I had the same probelm, ... but then noticed I had set "right-left" as display mode in the settings and was listening to a mono recording.