• eLeV8
  • ADAT user
  • Offline
  • Registered: 2010-05-17
  • Posts: 10

Topic: TotalMix crashes for 5 secs then starts again

Hi,

I have my RME Fireface 800 plugged into the rear Firewire800 port of my Mac Pro quad core via a Firewire800 cable.
Firmware 2.77
Driver 2.89
The red host light comes on for 5secs intermittently about 4 times every hour and when the red host light turns off again the Totalmix application stops for about 5 secs. Audio then starts again and the unit behaves normally but the TotalMix screen will have closed and needs to reopened.

Can anyone help please?
Cheers Olf

  • Jeff
  • Jeff
  • Moderator
  • Offline
  • From: USA
  • Registered: 2007-05-21
  • Posts: 4,666

Re: TotalMix crashes for 5 secs then starts again

Please try with all other FW devices disconnected from your Mac.

Regards,
Jeff Petersen
Synthax Inc.

Jeff's Website

  • eLeV8
  • ADAT user
  • Offline
  • Registered: 2010-05-17
  • Posts: 10

Re: TotalMix crashes for 5 secs then starts again

Thanks very much Jeff, you solved the issue.
I had a Firewire 400 cable plugged into the rear port on the Mac Pro but I did not have the other end connected to anything.
It was this floating cable that caused the drop outs. I assume that the Mac Pro FW bus searches for FW devices and if unable to find one at the end of an "empty"cable then it causes a firewire drop out.
I now have both my FF800s connected (one with FW800 cable the other with FW400) and at this stage there are no problems.

Blessings to you Jeff,
Olf