• Registered: 2009-07-12
  • Posts: 5

Topic: RME Fireface UC : Problem with Knob

Hi I have a RME Fireface UC, used to work on a machine with Win 7 32 bit with the old Totalmix mixer software.
I upgraded to the new Totalmix interface and updated the firmware on the Fireface UC after receiving my new computer, which uses Win 7 64-bit.
What I am experiencing now is this :

When I turn the knob, the volume changes as per the old totalmix software.
What is happening simultaneously as well is that the left/right PAN is also being controlled by the same knob. So when I am turning the knob, the volume fader is moving, but also the left/right pan as well.
This did not happen on the old totalmix software.

How do I get the knob to just control the volume fader as per before?

Thanks.

Pier.

  • Registered: 2009-07-12
  • Posts: 5

Re: RME Fireface UC : Problem with Knob

Found the solution here : http://www.rme-audio.de/forum/viewtopic.php?id=10097

  • xam
  • New member
  • Offline
  • Registered: 2009-06-23
  • Posts: 4

Re: RME Fireface UC : Problem with Knob

Hello I have also problem with this knob. I have  the last driver,
I cannot change easily from  channel to level.
I must push the knob a little bit  to the side, for the change, this seems new.

Thanks.

xam.

  • Registered: 2010-06-18
  • Posts: 34

Re: RME Fireface UC : Problem with Knob

Had this too..

Solution :

Pull the knob from the machine. Put a little piece of 1.5 mm thick paper or something in the knob and put the knob back.

Problem solved ? (Was for me.)

Arjan

Arjan S.
Pro-Found Recordings & SAE
Owns:Hammerfall9652,Multiface I,2xADI-8 Pro,Fireface UC.
  • xam
  • New member
  • Offline
  • Registered: 2009-06-23
  • Posts: 4

Re: RME Fireface UC : Problem with Knob

Today, after different moving try, it work again
thanks



xam