• Registered: 2011-04-05
  • Posts: 16

Topic: adjusting individual levels with two headphones

Is there any way to do this.  i think I read in the manual that the two headphone outs are electronically the same or something like that, and anything I tried didn't work.  Do do I need some external analog routing to do this?  I do have a behringer minimon, but think it will add noise.

I have phones 1, phones 2, and main showing in the totalmix control room. 

I just want to be able to adjust levels on two different headphones since one is a lot louder than the other, without making one the main out, which I can see does adjust independently from the headphones.

  • Jeff
  • Jeff
  • Moderator
  • Offline
  • From: USA
  • Registered: 2007-05-21
  • Posts: 4,621

Re: adjusting individual levels with two headphones

Which product do you have?

Regards,
Jeff Petersen
Synthax Inc.

Jeff's Website

3 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 24,902

Re: adjusting individual levels with two headphones

Connect one headphone to the normal analog line out via adapter, then it will work.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2011-04-05
  • Posts: 16

Re: adjusting individual levels with two headphones

Jeff wrote:

Which product do you have?

babyface, latest firmware and drivers

  • Registered: 2011-04-05
  • Posts: 16

Re: adjusting individual levels with two headphones

MC wrote:

Connect one headphone to the normal analog line out via adapter, then it will work.

hmmm . . . well I have my mic connected to that out, and would like to keep that dedicated.  Given that, I guess I'm back to the old behringer minimon . . .  unless there's some other way around it (?). 

thx for the replies