• Registered: 2009-06-30
  • Posts: 5

Topic: Problem Opening Sessions in Pro Tools 9: Sample Rate Sync Issue.

I am getting the following session error when trying to open up sessions
in Pro Tools when I have my RME HDSPe card set to Auto Sync:
"Pro Tools 9 could not set sample rate to specified value".

When I change it to master, then the sessions open up just fine. I would rather sync to my Mytek 8 x192 but suddenly this is not possible. I have recently updated my software to 10.7.1 and also my Pro Tools to 9.0.5. I did the normal trashing of the Pro Tools prefs etc. In my Pro Tools Play Back Engine settings, it is always set to the HDSPe.

This happens consistently, changing the settings back and fourth:
HDSPe set to Auto Sync: Session does not open.
HDSPe set to Master: Session opens normally.

Any help would be great. Equipment specs are below.

Mac Pro 2x2.26 Quad Core Intel
6 Gigs Ram
OSX 10.7.1
Pro Tools 9.0.5

RME HDSPe Card to
Mytek 8 x 192

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,777

Re: Problem Opening Sessions in Pro Tools 9: Sample Rate Sync Issue.

I expect a mismatch between fed clock and the clock that the project requires.

Regards
Matthias Carstens
RME

MC's Website