• Registered: 2011-06-11
  • Posts: 3

Topic: burl adc to ufx to babyface clock

I would like to use my Burl b2 adc into ufx aes, adding two inputs on the ufx. I would like the Burl clock out to connect to control ufx by clock out/in. I would like to connect my babyface by spidif to ufx to get four outs. This would give me a total of 12 outs. Would the babyface clock be controled by the Burl on spidif or adat? Will this work? I don't care if the babyface inputs. Will the babyface give me 4 outs at 192? Is there any special cabling in this setup? Thanks

  • vinark
  • DAW Mastermind
  • Offline
  • Registered: 2009-06-05
  • Posts: 2,782

Re: burl adc to ufx to babyface clock

I think you can only use the baby at 192 in adat smux, which IFAIK the UFX also supports. Clock the UFX from AES, no wordclock cable needed. The baby will the clock through adat from the UFX.

Vincent, Amsterdam
https://soundcloud.com/thesecretworld
BFpro fs, 2X HDSP9652 ADI-8AE, 2X HDSP9632