• Registered: 2012-05-15
  • Posts: 2

Topic: BabyFace input 2 gain issue

Hi, I am experiencing problems with input 2 on the baby face. It's gain setting changes randomly from 0 gain to max gain. This happens when adjusting ip 1 gain or ip 2 gain. They are Not stereo linked.
Similar problems happen when switching ip2 between inst and line. Any thoughts?

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,600

Re: BabyFace input 2 gain issue

Use latest driver and firmware.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2012-05-15
  • Posts: 2

Re: BabyFace input 2 gain issue

I have loaded the latest drivers and firmware but the problem is not resolved.

I have read in other post that it may be the pre amp chip. I will contact the vendor.

4 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,600

Re: BabyFace input 2 gain issue

The preamp chip can not cause this behaviour. Which driver, TM FX and firmware are you using now? Did you try to reset the current mix (Total reset) and build it up new?

Regards
Matthias Carstens
RME

MC's Website