• Registered: 2011-11-07
  • Posts: 23

Topic: direct recording playback channels

Hey everyone,

A newbie question: I can't seem to figure out how to play back all recorded channels directly from TotalMix.  Is it possible?  For example, if I have recorded some input and some output channels and then want to listen to the recording through the main outs I am able to only assign one stereo pair for playback.  I guess there is no way to do a playback mix?

Thanks,

Z

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,600

Re: direct recording playback channels

You can play back the recordings via the inputs and then use the TotalMix to mix the signals to one hardware output.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2011-11-07
  • Posts: 23

Re: direct recording playback channels

Thanks Matthias! What about the output channels since I have some software playback channels recorded on these?  Do I use the loopback function somehow? For example I am using output channels 5/6 to record some software synths.

z

  • Registered: 2011-11-07
  • Posts: 23

Re: direct recording playback channels

Nevermind:) Got it! Thanks again Matthias!  Just needed a little nudging..