• From: Indonesia
  • Registered: 2012-01-04
  • Posts: 7

Topic: totalmix peak led clipping point level (dBu/dBV)

i'm in the middle of DIY analog VU meter project, and i'm adding peak indicator circuit into the VU

and since i'm using RME 9632, i'm trying to match the VU Meter peak indicator clipping point with the peak led meter at Totalmix

and my question is:

at what level exactly (in dBu/dBV) the peak meter in Totalmix start to blink?

sorry for my bad english, and cheers from Indonesia big_smile

blinkerss's Website

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,431

Re: totalmix peak led clipping point level (dBu/dBV)

None of both. It starts as set up in the level meter setup dialog (F2) at 0 dBFS. The corresponding dBu value has tolerance and depends on the setting of the analog I/Os in the card's Settings dialog.

Regards
Matthias Carstens
RME

MC's Website