• Registered: 2013-06-03
  • Posts: 2

Topic: HDSPe Raydat: No signal at AES output with Pro Tools 10

I did use my Raydat with Nuendo for 2 years and now I changed to Pro Tools 10. When I finished the Pro Tools Installation it already did recognize my Raydat Card. Pro Tools already made the correct routing. In- and ouputs of ADAT1-4 work perfectly but I can´t get a signal out of channels 33/34(AES) and channels 35/36(S/PDIF). When I open the Hamerfall mixer, I can´t see any signal on these channels although they are routed correctly in Pro Tools. Does anyone have an idea what´s the problem? Do I have to Switch on the digital outputs somewhere in the RME Setup?
Thanks for your help!

Tom

  • Registered: 2013-06-03
  • Posts: 2

Re: HDSPe Raydat: No signal at AES output with Pro Tools 10

Ah ok, right now I did read about a 32 I/O limitation of Pro Tools with non AVID Hardware. I´ll use 2 ADAT channels for that and route it to the AES Output.