• Registered: 2013-08-16
  • Posts: 8

Topic: Headphone output

Hi

I'm brand new to this kit, so please bear with.

I can't get a signal to the PH7/8 jack so that I can listen through headphones. The headphones are fine BTW.

I have the mic signal going in on Mic 1 and appearing on AN1. I'm selecting PH7/8 at the bottom of the input fader.

Nothing is appearing in the 'control room' fader (it was earlier, don't know what I did but I still had no headphone output).

Been trying to get this to work for 3 hours now, gets in the way of the music doesn't it? Been searching the manual too.

Can anyone help?

2 Reply by neirbod (edited by neirbod 2013-12-17 22:16:57)

  • From: Washington DC, USA
  • Registered: 2007-08-06
  • Posts: 442

Re: Headphone output

Signal routing in Total Mix can be confusing at first, but becomes very intuitive once you understand how it works.  I suggest spending a little time watching the tutorial videos published by Synthax.  It will save hours of headaches:

http://www.youtube.com/watch?v=sCH3qVaLL-I
http://www.youtube.com/watch?v=7O5i3s29Id4

  • Registered: 2013-08-16
  • Posts: 8

Re: Headphone output

thanks for that - will do.