• Registered: 2011-04-25
  • Posts: 42

Topic: AES 32 Total Mix Mixer- Cubase Direct Monitoring Question/Problem

Hello,

I am using Cubase 6 on a Windows 7 PC.

I enabled Direct Monitoring in Cubase and created 8 mono tracks and armed them in monitor mode. I enabled  "Asio Direct Monitoring" in my RME HDSP  Mixer and pulled the Cubase faders up to see if the corresponding RME faders  behaved accordingly. Faders 2-8 corresponded with Cubase all the way up to 6.0. However, Fader 1 stopped at -11.1.

Could someone explain why fader 1 didn't respond like faders 2-8?

Thanks for your help.

http://i380.photobucket.com/albums/oo249/Domer81/DAW/RME2.png
http://i380.photobucket.com/albums/oo249/Domer81/DAW/Cubase.png

Cubase 6 64 bit, Windows 7, RME AES HDSP-32, Lynx Aurora 16. Bricasti M7, API 2500, etc.

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,777

Re: AES 32 Total Mix Mixer- Cubase Direct Monitoring Question/Problem

You set up a fader group in TM that prevents the fader from moving higher.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2011-04-25
  • Posts: 42

Re: AES 32 Total Mix Mixer- Cubase Direct Monitoring Question/Problem

MC wrote:

You set up a fader group in TM that prevents the fader from moving higher.

Thanks for your reply Mathias. I didn't intentionally do that, but I'll check the manual for fader group set ups and find out how to undo the fader set up that is preventing the fader from moving higher.

Thanks again.

Frank

Cubase 6 64 bit, Windows 7, RME AES HDSP-32, Lynx Aurora 16. Bricasti M7, API 2500, etc.

4 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,777

Re: AES 32 Total Mix Mixer- Cubase Direct Monitoring Question/Problem

It's too new for the manual, but it is obvious (Grp1 shown in your screenshot) and easy to use via the menu.

Regards
Matthias Carstens
RME

MC's Website