• Registered: 2022-09-21
  • Posts: 18

Topic: Outputting my computer's audio through my Fireface UCX II?

Hi, I've been using my Fireface UCX II with my Shure SM7B microphone to record YouTube videos, so far it's been working really well. However, I was having an issue where my PC's audio was also being captured by my microphone, so I decided to get a pair of DT 700 Pro X headphones to remedy this.

I've connected the headphones to my audio interface, but I'm not really sure how to have the headphone output just my PC's audio, and not the audio from my microphone. Does anyone know how I might go around doing this?

Any help is greatly appreciated!

2 Reply by ramses (edited by ramses 2024-04-01 05:40:57)

  • ramses
  • DAW Mastermind
  • Offline
  • From: UTC+1
  • Registered: 2012-10-14
  • Posts: 13,197

Re: Outputting my computer's audio through my Fireface UCX II?

Through the corresponding routing in TotalMix FX. There is information on this in the manual and on YouTube.
See also this thread: https://forum.rme-audio.de/viewtopic.php?id=34394

In brief:

Initial prerequisite: submix mode is activated.
Click on the hardware output of the headphones (TM FX bottom row).
Now you can see the submix setting for the selected output from the fader position in the top and middle rows.
Now set the faders of the HW Inputs (top row) and SW Playbacks (audio from PC, middle row) as you want them
(pull faders up or down).
This is the case for each output, each has its individual submix.

BR Ramses - UFX III, 12Mic, XTC, ADI-2 Pro FS R BE, RayDAT, X10SRi-F, E5-1680v4, Win10Pro22H2, Cub14
  • Registered: 2022-09-21
  • Posts: 18

Re: Outputting my computer's audio through my Fireface UCX II?

Thanks so much for the help!