• Registered: 2015-02-14
  • Posts: 27

Topic: Multiface II with Version 1 HDSP PCI card ?

Hi again, I was also wondering if it is possible to use the Multiface II with the first generation HDSP PCI card version 1.8 ?
I read that anything earlier than a version 1.9 will not have enough current  to power the Multiface II but have seen some references to using a power supply withe the box. If that is the case, Has anyone done this and what size power supply would be needed for a no issue setup?
Thanks so much.

  • From: Germany
  • Registered: 2007-04-10
  • Posts: 9,850

Re: Multiface II with Version 1 HDSP PCI card ?

The only potential issue is that indeed you might need external power for the MF. Everything else will work fine.

Regards
Daniel Fuchs
RME

Regards
Daniel Fuchs
RME

RME Support's Website

3 Reply by Shadow (edited by Shadow 2015-02-15 16:35:50)

  • Registered: 2015-02-14
  • Posts: 27

Re: Multiface II with Version 1 HDSP PCI card ?

Hi Daniel, thanks for the reply. So all I need is a power supply and it should work fine? That would be fantastic. I think I would need something more than my cardbus power supply...Can you recommend what volts and amps would be needed?
Thanks again

*edit* never mind.. I see you answered that in my other post...12 volt - 2 amps..  Thanks!