1 Topic by fabien (edited by fabien 2015-01-02 12:39:44)

  • Registered: 2015-01-02
  • Posts: 2

Topic: Mapping MIDI Total mix

I would like to map total mix in a midi controller :

The faders of 8 tracks ; the mute ; the solo (8 faders + 2 buttons per track)
The EQ : Gain db Low ; Medium ; Hi, (3 knobs per track)
Eventually the reverb ; delay (2 knobs )

Is this layout envisageable?


Thanks!
fabien

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,599

Re: Mapping MIDI Total mix

These are your choices:

8 faders  - see manual, either Mackie protocol or CC. Mute and Solo per channel - only Mackie protocol. EQ - not supported. Reverb/Delay On/Off (or any controls) - not supported.

Using OSC it is possible to control all these. But most probably your MIDI controler does not support that protocol...

Regards
Matthias Carstens
RME

MC's Website

  • Deny
  • New member
  • Offline
  • Registered: 2016-10-28
  • Posts: 6

Re: Mapping MIDI Total mix

Depending on what you need to do, it may be possible to work around TotalMix' MIDI implementation limitations using Mix Snapshots - you can use up to 8 of them and recall them using MIDI messages (notes).

As for the faders, it's a bit easier, see the second post:
https://www.forum.rme-audio.de/viewtopi … 38#p115338