Topic: ADI-2 Pro: Problems using Powerbank Xoro MPB 1500
I want to use this powerbank: https://www.amazon.de/dp/B00LPHRBPO/ref … TE_3p_dp_1
But something goes wrong ...
1. I loaded the powerbank to 82% and then plugged it into the ADI-2 Pro.
2. When turning on the ADI-2 Pro, somthing like an internal relay in the ADI-2 Pro is instantly
flipping at high rate ~3-4x per second.
3. The connected headphone on port 3/4 is also making klicks and pops at the same rate.
Powering on the ADI-2 Pro only works, when I plug the power cable into the 9/12V plug (output) of the Xoro.
Then the display becomes lit. Otherwise nothing happens.
The Display shows 9V.
Whats wrong ? Any idea ?
EDIT: on the right side there is a switch to set the output to 12V.
But this doesn't make any difference.
BTW, while there is this "relais clicking noise", the power-off knob of the ADI-2 Pro doesnt work immediately, it lasted some time until it became active to power off the device.
EDIT2: I clicked now several times on the right button on the Xoro, thought maybe the 12V are not locked, as it was blinking. And then the "clicking noise" vanished.
But I thought/hoped too early. After about 30-60sec after powering on the ADI-2 Pro it started again. This time not directly from the beginning .. but again ...
Up to now I didn't get any working result.
X10SRi-F, E5-1650v4, Win10 Pro 2004, Cubase 10.5.20, UFX+, XTC, ADI-2 Pro FS R BE, ARC USB