• From: Novosibirsk, Russia
  • Registered: 2011-05-16
  • Posts: 86

Topic: Sample rate and format changing for input 1/2. How to.

Hi all,
How to setup more than 192Khz sample rate or change from PCM to DSD?
Clock menu is gray.
Only one way changing sample rate is do this in DigiCheck. But again no more than 192 and only PCM.

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,582

Re: Sample rate and format changing for input 1/2. How to.

Sample rate in USB operation is changed in the Settings dialog and requires Internal Clock mode and no ASIO software running. See manual.

Regards
Matthias Carstens
RME

MC's Website

  • From: Novosibirsk, Russia
  • Registered: 2011-05-16
  • Posts: 86

Re: Sample rate and format changing for input 1/2. How to.

I'm read this in manual. But how to record input analog signal to comp via USB with PCM 768?

4 Reply by jchan (edited by jchan 2017-04-01 15:50:21)

  • jchan
  • AD/DA expert
  • Offline
  • From: Stockholm
  • Registered: 2011-01-17
  • Posts: 52

Re: Sample rate and format changing for input 1/2. How to.

Recording with what software? Pro Tools Native its max 192 (HD 384/768). But for OS X sample rate must be changed in audio / midi setup

5 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,582

Re: Sample rate and format changing for input 1/2. How to.

He uses Windows, but you are right, it is the software where this is set then - if possible. DIGICheck is limited to 192 kHz operation as well. For example Reaper can do.

DSD is greyed out as long as the sample rate is below 176.4 kHz.

Regards
Matthias Carstens
RME

MC's Website