> Is it okay to connect the cables of my monitoring speakers to any 6 Balanced Output
>( without to care About wihch speaker is in the left or the right ? )
It doesn't matter, but for the panning (Left/Center/Right) to work correctly in TotalMix FX,
you should take care and plug correctly. 1L, 2R, 3L, 4R etc ...
> And i Like that the Signal go direcktly to the Main out 1-2.
1. Assign a channel for Main Out, i.e. Analog 1/2 in TotalMix FX (Control Room Section lower right, assign button).
2. Then Reset TotalMix by this default routing which is being offered by TotalMix very user friendly.
3. Then store this basic setting as Snapshot 1, you can also give it a name if you like by double clicking to its standard name.
4. Then position the TM FX Window as you prefer and then store the settings
File -> Save Snapshot As ...
File -> Save Workspace As ...
5. I would also recommend to store this routing permanently to the device
Options -> Store Current State Into Device -> Setup 1 (of 6 stand-alone profiles)
6. Then I would set in preferences, that TotalMix settings override / preconfigure the UCX on every new boot of computer,
then you have always a defined starting point and correct volume etc.
Options -> Preferences (F2) -> Always init DSP device with TotalMix FX settings
> I m Not looking to use much complicated Routing.
Its all easier than you think and can know at this point.
> There re some turorials About the setting in YouTube or hier in Forum ?
Yes, I have in my Blogs a collection of extremely good RME Youtube Videos explaining TotalMix
and I wrote an article about the 1st steps with TotalMix FX as kind of a "Primer" in German and English.
http://www.tonstudio-forum.de/blog/inde … al-Videos/
http://www.tonstudio-forum.de/blog/inde … teps-DE-E/
> Much Thanks for the help.
You're welcome.
BR Ramses - UFX III, 12Mic, XTC, ADI-2 Pro FS R BE, RayDAT, X10SRi-F, E5-1680v4, Win10Pro22H2, Cub13