• mitr
  • ADAT user
  • Offline
  • Registered: 2018-04-08
  • Posts: 20

Topic: Multiple DACs with one remote control

Would a single remote control device operate 3-4 ADI-2 DACs with sufficient precision for use as a master VC for multichannel playback?

  • From: Germany
  • Registered: 2007-04-10
  • Posts: 9,770

Re: Multiple DACs with one remote control

Haven't tried, but I see no reason for this not to work....


Regards
Daniel Fuchs
RME

Regards
Daniel Fuchs
RME

RME Support's Website

3 Reply by mitr (edited by mitr 2018-06-06 23:17:42)

  • mitr
  • ADAT user
  • Offline
  • Registered: 2018-04-08
  • Posts: 20

Re: Multiple DACs with one remote control

RME Support wrote:

Haven't tried, but I see no reason for this not to work....

Thanks but is there any way to really find out?  One should not have to buy 3 of them just on a speculation.

4 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,586

Re: Multiple DACs with one remote control

Such a setup is destined to fail. There is no guarantee all units process the remote info identically, nor that the remote beam hits all units always the same way. In a real-world multichannel system (surround) you will not have identical volume settings on all units, a deviation in volume will sneak in unnoticed.

Regards
Matthias Carstens
RME

MC's Website

  • mitr
  • ADAT user
  • Offline
  • Registered: 2018-04-08
  • Posts: 20

Re: Multiple DACs with one remote control

MC wrote:

Such a setup is destined to fail. There is no guarantee all units process the remote info identically, nor that the remote beam hits all units always the same way. In a real-world multichannel system (surround) you will not have identical volume settings on all units, a deviation in volume will sneak in unnoticed.

Thanks.  Clear enough, unfortunately.