Topic: Understanding And Setting Up Digicheck - Beginner

Thanks for looking at this and for any thoughts. I'm a new user and need to get to grips with Digicheck. I have the RME UFX 2. I use the Arc USB as my monitor level controller and I'm working with Logic X 10.4.4.

I'd like to be able to use Totalyser, and all other functions, at the signal level not my monitoring level. At the moment if I turn my monitors down the levels in Totalyser also go down. What I'd like is for Digicheck to monitor the audio at main volume fader 0Db and for me to be able listen at any level I like. I've had a good look at the forum and online but can't see anything that helps with this. I understand it may be out there and I just don't yet know what I'm looking at yet.

I'm guessing it might be a TotalMix routing solution but I'm not familiar enough to know how to set it up. At the moment all playback, system and Daw, comes through AN 1/2.

If there is a way of having Digicheck work on playback signal strength, equivalent to main volume fader at 0Db, while I monitor at any level that would be really helpful.

If somebody could point me in the right direction I'd be enormously grateful.

Thanks.

Re: Understanding And Setting Up Digicheck - Beginner

So I think I've done it. If anybody sees an obvious flaw with this would you mind letting me know?

Select Software Playback ADAT 15/16. Bring playback volume up to 0Db (AN 1-2 in this instance). Select loopback on ADAT15/16 and adjust Digicheck inputs to reflect the same.

Job done.

Re: Understanding And Setting Up Digicheck - Beginner

Looks good...

Regards
Daniel Fuchs
RME

Re: Understanding And Setting Up Digicheck - Beginner

Thanks Daniel. Working beautifully. Next job is to learn how to use the various tools properly.