Topic: RME FireFce UFX II using ADAT and Word Clock simultaneously
Hi All,
I would like to know if this configuration would work if I connected these three devices together. The question is the clocking sync.
1) RME FireFace UFX II as the main interface, I would like it to be the MASTER clock, set to internal
2) Focusrite Clarett 8PRE in standalone mode. It has ADAT IN/OUT and a Word Clock out only. So I connect this with both ADAT IN and OUT with the FireFace Adat OUT/IN. It works fine so far. The Clarett is a SLAVE.
3) I would like to extend the preamps with an Audient ASP800. The ASP800 has ADAT OUT and Word Clock IN. So, what happens if I connect the FireFace Word Clock OUT to this Word Clock IN of the Audient?
I could connect all the WC terminals like this: Clarett WC OUT -> RME WC IN, RME WC OUT -> Audient WC IN. But in this case, the Clarett would be the master which I do not like to.
So the question: If I connect the RME and Focusrite with both ADAT IN / OUT, and at the same time, I connect the RME WC OUT to the Audient WC IN, would the whole setup work perfectly synched?
thanks, guys
Peter