1 Topic by jotfisch (edited by jotfisch 2020-01-06 15:07:07)

  • Registered: 2018-11-12
  • Posts: 2

Topic: combining DigifaceDante with Fireface

if I use both DigifaceDante and Fireface 802 on an apple macbook by using a created Aggregate Device,

is it possible to rout signals to the outputs of both devices?

Is it possible within the Totalmix software to rout a signal from Fireface analog input directly to a DigifaceDante output???

Does anyone know?
best
jens

  • Jeff
  • Jeff
  • Moderator
  • Offline
  • From: USA
  • Registered: 2007-05-21
  • Posts: 4,666

Re: combining DigifaceDante with Fireface

is it possible to rout signals to the outputs of both devices?

Only in the DAW software. TotalMix runs independently on each unit.

Is it possible within the Totalmix software to rout a signal from Fireface analog input directly to a DigifaceDante output???

Not with these two units. You would need to make a physical connection from FF802 out to Digiface Dante input. If you had a Fireface UFX+ instead of the Fireface 802, you could make this connection with a MADI coax cable.

Regards,
Jeff Petersen
Synthax Inc.

Jeff's Website

  • Registered: 2018-11-12
  • Posts: 2

Re: combining DigifaceDante with Fireface

Thank you Jeff!
thats not the answer I was hoping for ;-)
but very helpful.
best
jens