1 (edited by enriquesilveti 2020-03-12 18:26:42)

Topic: ADI-2 PRO FSRm how to monitor analog inputs thru PH3/4

I'm using a black ADI-2 PRO FSR in mutichanel USB mode and I'm sending audio to external analog hardware.
The output of this external analog hardware go to ADI-2 PRO FSR analog inputs 1/2 but I don't know if it is possible to monitor the analog inputs 1/2 thru the phones PH3/4.

NOTE: latest firmware plus latest driver (non beta).

Thank you.

Saludos Enrique.

Re: ADI-2 PRO FSRm how to monitor analog inputs thru PH3/4

There is no TotalMix in the ADI-2 Pro.

Enrique, you just need to set the source for Phones 3/4 on the front panel menu. Press the I/O button, turn the (1) knob to select Phones Out 3/4, then set Source: Analog.

Regards,
Jeff Petersen
Synthax Inc.

Re: ADI-2 PRO FSRm how to monitor analog inputs thru PH3/4

Jeff wrote:

There is no TotalMix in the ADI-2 Pro.

I didn't read closely, thanks for the correction, Jeff wink

BR Ramses - UFX III, 12Mic, XTC, ADI-2 Pro FS R BE, RayDAT, X10SRi-F, E5-1680v4, Win10Pro22H2, Cub13

Re: ADI-2 PRO FSRm how to monitor analog inputs thru PH3/4

Thank you for the answer Jeff.
(no problem ramses, wrong answer = you are getting old...)

I tried, however, when the phone has connected on 3/4 the loopback (ADI PRO AN 1-2 OUT -> Analog Hardware I/O-> ADI PRO AN IN 1-2) into the host/DAW is stopped via the USB/ASIO driver.

I know ADI PRO is not an audio interface! But I was just wondering is it is possible. If no, Which RME hardware you suggest to me?

Thank you,

Saludos Enrique.

5

Re: ADI-2 PRO FSRm how to monitor analog inputs thru PH3/4

You have to disable the automatic mute on analog out 1/2 when Phones are plugged in. Setup, Phones, Mute vs Phones 3/4...

Regards
Matthias Carstens
RME