hfasher wrote:The BFP allows me to select optical in but it states that the current clock is internal.
Unclear statement. Is the UFX clock master (Internal) in your setup? Then the BF Pro must be set to Optical In as clock source.
hfasher wrote:Using ADAT 2 I am able to get sync with UFX (slave) however the channels do not show in the BFP total mix window like the ultra gain.
Using ADAT 1 you would also get Sync. Using ADAT 2: are you sending out something on those channels in TM FX of the UFX? And is ADAT2 set to AES/SPDIF? Then no signal there...
hfasher wrote:I was hoping that by syncing the Babyface to the UFX that its four extra channels would show in the UFX Total Mix Window allowing me to monitor all channels through The outputs of the UFX. Is that even possible?
Now you are talking about the 4 Babyface Pro inputs? You need to use the BF Pro TM FX and route its inputs to the BF Pro ADAT output, plug this into the UFX and the signals will be seen there. IF the clock situation is correct.
Regards
Matthias Carstens
RME