• Registered: 2020-11-23
  • Posts: 3

Topic: FIREFACE 800 - setting up external Reverb for monitoring?

man, i love this interface. I've used it for years and it sounds so much better than my apogee DUET.
(Do the newer RME products also sound this good?)

Anyway, question: This has no built in monitoring FX. Is there a way I can use an external rev/del so I can hear some ambience when tracking vocals? My brain isn't naturally wired for this kind of thing (totalmix gives me a bit of a panic attack) but i'm getting there. Any help much appreciated.

  • From: Germany
  • Registered: 2007-04-10
  • Posts: 9,769

Re: FIREFACE 800 - setting up external Reverb for monitoring?

You don't really need Totalmix... The send/return configuration is a matter of your DAW software, TM can be left at defaults.

Regards
Daniel Fuchs
RME

Regards
Daniel Fuchs
RME

RME Support's Website

  • Registered: 2020-11-23
  • Posts: 3

Re: FIREFACE 800 - setting up external Reverb for monitoring?

Thanks for a fast reply

Thing is, I'm trying to avoid monitoring through the DAW for latency reasons. Is there not a way i can set up an FX return through total mix?

Tom

4 Reply by MetalHeadKeys (edited by MetalHeadKeys 2020-11-24 17:25:48)

  • Registered: 2019-10-01
  • Posts: 675

Re: FIREFACE 800 - setting up external Reverb for monitoring?

Hello!

Could you take a look at this thread?

https://forum.rme-audio.de/viewtopic.php?id=31185

The only difference with your situation is that, at the final step you just need to raise the fader of the Input you have your Mic connected to!

RME Gear: Digiface USB, HDSP 9632