Topic: FireFace UFX+: Power Switch & Loopback
Since November 2020 I use the RME FireFace UFX+ as a new AudioInterface. Everything was working fine.
1. Since ~February 2021 I realiszed that the Powerswitch does not work anymore. Fortunately the hardware device stays always ON, but cannot be switched off anymore. Temporarly solution is using an external switchable power supply.
-> This behavior is already reported in this forum. Any ideas regarding RME to solve this? Is it possible to get 1:1 change of the hardware device?
2. Yesterday I noticed another problem:
I'm using loopback on ADAT 1/2 - Some inputs a routed to the loopback, but the ADAT1/2 does not deliver any signal into my DAW or other external Applications (OBS, Skype, etc)
This was working fine before and there were no changes within the setup. I tried to use another loopback (e.g. MADI5/6..) same issue. As shown in TotalMix FX the loopback is getting the signals, but as said before the ADAT 1/2 or MADI 5/6 does not route any signal to the external applications.
I Updated the device to the latest firmware (only DSP part was renewed) - this did not help.
I loaded the factory defaults and created a new setup via TotalMix FX - this did also not help.
Any suggestions what might be wrong?
THX,
KarbaS