• Registered: 2022-04-05
  • Posts: 2

Topic: Use more than one DigifaceDante

I'd like to use 2 of DigifaceDante as 96k/64Channels Dante/USB Audio Interface.

I had read 'Using more than one Digiface Dante is currently not supported. ' in a UserManual.

Will this be resolved in the future?

  • Jeff
  • Jeff
  • Moderator
  • Offline
  • From: USA
  • Registered: 2007-05-21
  • Posts: 4,617

Re: Use more than one DigifaceDante

You can chain the 2nd Digiface Dante unit to the primary unit via the MADI coaxial connection. When used stand alone (no USB cable connected) the Digiface Dante works as a format converter for MADI <> Dante.

Regards,
Jeff Petersen
Synthax Inc.

Jeff's Website

3 Reply by gelshx (edited by gelshx 2022-04-08 01:29:38)

  • Registered: 2022-04-05
  • Posts: 2

Re: Use more than one DigifaceDante

Jeff wrote:

You can chain the 2nd Digiface Dante unit to the primary unit via the MADI coaxial connection. When used stand alone (no USB cable connected) the Digiface Dante works as a format converter for MADI <> Dante.

Thanks for reply Jeff. I want to pre-timealign audio between Dante and MADI(from 2nd DigifaceDante Standalone) . Do I have to offset recorded tracks after recording?

4 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 24,823

Re: Use more than one DigifaceDante

In that setup the difference between both Dante streams should be a few samples only (3 to 6).

Regards
Matthias Carstens
RME

MC's Website