• Registered: 2022-08-27
  • Posts: 4

Topic: Total Mix ADAT Configuration for Live 11

Hello all,

I'm hoping someone could help me diagnose what may be a routing or clocking issue between Total Mix fx and Ableton live.

I have recently upgraded to a FF UCX from a FF 800 but would like to keep the FF 800 for additional connectivity. They are connected via ADAT.

FF 800 ADAT 1 OUT --> FF UCX ADAT IN --> MPB M1

Clock Mode of FF 800: AutoSync
Clock Mode of UCX: Internal
Samplre rates are all set to 44100 Hz

I am currently successfully receiving signal in Total Mix from the ADAT of the FF 800 but I cannot seem to find a way to receive the ADAT signal in Live. I have search Ableton's forums but could not find anything relatable there.

Any help would be most appreciated.

Thank you,
J

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,604

Re: Total Mix ADAT Configuration for Live 11

Clock Mode UCX must be set to AutoSync. Unless you did not disclose the path UCX ADAT Out --> FF800 ADAT In.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2022-08-27
  • Posts: 4

Re: Total Mix ADAT Configuration for Live 11

Thanks for such a prompt reply Matthias, this resolved the issue. Much appreciated.

Is my understanding correct; different sample rates change the available analog outputs? I have changed the sample rate to 48hz.

Now that I have UCX ADAT Out --> FF800 ADAT In will I still be able to access the 8 analog outputs from the FF 800 or at 48hz does that change to 4 analog outputs?

Thank you,
J

4 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,604

Re: Total Mix ADAT Configuration for Live 11

?????

96 kHz would reduce to 4 channels via ADAT.

Regards
Matthias Carstens
RME

MC's Website