• ramses
  • DAW Mastermind
  • Online
  • From: UTC+1
  • Registered: 2012-10-14
  • Posts: 13,187

Topic: Possible to use stock XLR->TRS cable for unbalanced connection?

Hi,

I need to connect a guitar pedal to UFX+, HW output Analog 1/2 (the output with XLR connectors).

Not 100% sure, could I use a stock XLR -> TRS cable for such an unbalanced connection?
Any negative side effect?

BR Ramses - UFX III, 12Mic, XTC, ADI-2 Pro FS R BE, RayDAT, X10SRi-F, E5-1680v4, Win10Pro22H2, Cub14

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,586

Re: Possible to use stock XLR->TRS cable for unbalanced connection?

As mentioned in the manual - Pin 3 should be disconnected as chances are that R will be shorted to GND within the peadal.

Regards
Matthias Carstens
RME

MC's Website

3 Reply by ramses (edited by ramses 2022-09-19 11:29:16)

  • ramses
  • DAW Mastermind
  • Online
  • From: UTC+1
  • Registered: 2012-10-14
  • Posts: 13,187

Re: Possible to use stock XLR->TRS cable for unbalanced connection?

Thanks, Matthias.

Am I right in thinking that it is safe to just try it out?
If something shorted out from the pedal, would it be noticeable?
A poorer quality would be unfavorable if you would notice it later.

BR Ramses - UFX III, 12Mic, XTC, ADI-2 Pro FS R BE, RayDAT, X10SRi-F, E5-1680v4, Win10Pro22H2, Cub14

4 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,586

Re: Possible to use stock XLR->TRS cable for unbalanced connection?

I expect the pedal not to need full/max level, that would help with distortion, and yes, nothing will break, so you could try it.

Regards
Matthias Carstens
RME

MC's Website