Topic: FF800 and Totalmix

Anyone have a bug where your hardware input is set to goto a specfic hardware output, and all of a sudden it sends itself to another hardware output as well?

I'm using Nuendo 12 on  Win 10.

Thanks.

2

Re: FF800 and Totalmix

MIDI control?

Regards
Matthias Carstens
RME

3 (edited by uplift productions 2022-09-12 15:59:58)

Re: FF800 and Totalmix

as in total mix is receiving a midi signal?

Midi is turned off in Total Mix.

4

Re: FF800 and Totalmix

Sounds like ADM control, with Nuendo doing this (if the faders equal that routing). Otherwise it might even be software monitoring.

Regards
Matthias Carstens
RME

Re: FF800 and Totalmix

I just turned off ASIO monitoring in Total Mix, I'll see if that helps.

Re: FF800 and Totalmix

i need direct monitoring enabled, so its a bad workaround. I took a video of it happening. Can I forward it somewhere?

Re: FF800 and Totalmix

Any help would be appreciated.

Re: FF800 and Totalmix

https://youtu.be/Yu7DIu-hROs

9

Re: FF800 and Totalmix

If you insist on ADM then you should not use mono Outputs in TM FX:  Options, Reset Mix - click on 'Set inputs mono / outputs stereo (ADM).

But you could also check if the issue still exists with the latest TM FX version 1.77:

Link removed.

Regards
Matthias Carstens
RME

Re: FF800 and Totalmix

Can I use 1.77 with a FF800? I stopped updating because I thought I was stuck at 1.60

11

Re: FF800 and Totalmix

You can also use 1.78:

https://www.rme-audio.de/downloads/tmfx_win_178.zip

Regards
Matthias Carstens
RME