• Registered: 2022-10-05
  • Posts: 2

Topic: Multiple Speaker Monitors

Hello,

I would like to use multiple speaker monitors and easily switch between them. Currently I am using the RME ARC-USB controller to toggle between Speaker A and Speaker B. But what if I want to add a 3rd pair? or just add a single mono speaker? Anyone else doing something like this?

Thnaks

2 Reply by ramses (edited by ramses 2022-10-06 07:12:23)

  • ramses
  • DAW Mastermind
  • Offline
  • From: UTC+1
  • Registered: 2012-10-14
  • Posts: 13,197

Re: Multiple Speaker Monitors

Hi and welcome to the forum.

Where is the problem?

You route audio to the 3rd speaker pair and save this routing to another TM FX snapshot,
so that it is easily switchable and recallable in either TM FX or by using the ARC USB.

The HW output does not necessarily have to be in the TM FX control room (by using assign).

But if you want to have control room features as well for this speaker pair,
then push “Assign” and assign one of the free slots / predefined definitions, like “Phones 2” (or 3 or 4).

Routing is easiest to configure in “submix” mode, check this setting in TM FX in the light blue area on the right.

Sources of information about routing in this sticky: https://forum.rme-audio.de/viewtopic.php?id=34394

BR Ramses - UFX III, 12Mic, XTC, ADI-2 Pro FS R BE, RayDAT, X10SRi-F, E5-1680v4, Win10Pro22H2, Cub14