• Registered: 2020-08-14
  • Posts: 109

Topic: UFX ii, Cubase Pro 12, trying to set Cranborne 500ADAT as clock source

Hello,


I changed clock source to be ADAT 1 and on USB setting of UFX ii, it is all good to go.


But on my Cubase 12 setup, 'Clock Source' is greyed out, and says 'internal'.
But below, I ticked on 'Externally Clocked'

Also, 'HW sample rate' it states 48k (externally clocked)


Is this just bug on Cubase, or 'internal' cannot be changed..?


Any Cubase/UFX users would be so much helpful for me cheers!


Other settings are perfectly done on my side.

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,599

Re: UFX ii, Cubase Pro 12, trying to set Cranborne 500ADAT as clock source

The audio interface's clock source is NOT set in Cubase, ignore that setting.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2020-08-14
  • Posts: 109

Re: UFX ii, Cubase Pro 12, trying to set Cranborne 500ADAT as clock source

aha.. thank you! at first, it got me confused smile I will ignore it thanks.

4 Reply by waedi (edited by waedi 2023-01-23 06:53:32)

  • waedi
  • DAW Mastermind
  • Online
  • From: Swiss Zürich
  • Registered: 2020-12-08
  • Posts: 4,549

Re: UFX ii, Cubase Pro 12, trying to set Cranborne 500ADAT as clock source

This setting is for Steinberg Interfaces.
They implemented a lot of their interface settings into Cubase.
Marketing strategy, make users believe they lose Cubase features without Steinberg interface.

M1-Sequoia, Madiface Pro, Digiface USB, Babyface silver and blue

5 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,599

Re: UFX ii, Cubase Pro 12, trying to set Cranborne 500ADAT as clock source

Nope. This setting has been there forever. It is for drivers that allow external control of clock settings and latency (buffer size). When ASIO started Steinberg made it as flexible as possible. But both settings are unpractical to be handled externally, outside the driver, so they are found very seldom implemented like that

Regards
Matthias Carstens
RME

MC's Website