Topic: RME ADI 8 DS - Calibration
Hi,
Just a bit baffled with this.
In Studio One 6 - Main Output shows around 5-6db of headroom, if I push up from this the ADI 8 goes into clipping on the input state.
If I keep the ADI-8 out of clipping, the printed mix has 5-6db of headroom which I normalize and bounce. If I play that file - RME clips again as before.
My system is set for +4db nominal including the RME. It is chained to a UAD Apollo, the meters of which also show plenty of headroom.
Whats the shizzle?
Cheers,
GRiFF