Topic: Digiface AES - Route Mic for Google Meet
This was pretty easy with my Babyface Pro. I recently purchased a Digiface AES and there is no audio from my microphone connected on mic/line 1. Any help would be appreciated.
You are not logged in. Please login or register.
RME User Forum → TotalMix FX → Digiface AES - Route Mic for Google Meet
This was pretty easy with my Babyface Pro. I recently purchased a Digiface AES and there is no audio from my microphone connected on mic/line 1. Any help would be appreciated.
This was pretty easy with my Babyface Pro. I recently purchased a Digiface AES and there is no audio from my microphone connected on mic/line 1. Any help would be appreciated.
In Totalmix input channel 1 is no signal visible ?
if you use a condenser mic the phantom power 48V is ON ?
dubiousdavid wrote:This was pretty easy with my Babyface Pro. I recently purchased a Digiface AES and there is no audio from my microphone connected on mic/line 1. Any help would be appreciated.
In Totalmix input channel 1 is no signal visible ?
if you use a condenser mic the phantom power 48V is ON ?
I've got the gain set properly and phantom power is not needed. I'm using the same setup that I had with the babyface.
A screenshot of Totalmix would be helpful.
Hopefully you don't have activated Loopback ?
You most probably mean that a signal is there in TM FX level meter, but not recorded. It should be obvious that these are channels 1/2 on the Babyfcae, but channels 5/6 at the Digiface AES, so you need to change settings in your recording software. I don't know Google meet, if that one is fixed to 1/2 then you could use the usual workaround with Loopback on output 1/2 activated.
The Babyface and the Digiface AES seems to have a different channel order.
In Babyface the Input channel 1 receives signal from Mic 1
In Digiface AES the Input channel 5 receives the signal from Mic1.
In the Matrix window you can see it.
For routing the mic to the input channel 1 you have to use Loopback in the Output channel AES.
Route the Mic input 1 to the hardware output AES and activate Loopback, open the AES channel with the wrenchtool button.
Then Google Meet will receive the mic.
That worked. Thank you so much!
RME User Forum → TotalMix FX → Digiface AES - Route Mic for Google Meet
Powered by PunBB, supported by Informer Technologies, Inc.