• Registered: 2023-11-03
  • Posts: 9

Topic: 12Mic-D + DAD AX24 connected via MADI to the RME

Hello,

12Mic-D + DAD AX24 connected via MADI to the RME:

My 12Mic-D is a slave to my DAD AX24 via worclock. How can I ensure that the DAD is MasterClock in the DANTE controller, given that only the RME is visible there (the DAD via MADI obviously does not appear)?

Thanks for your help !

  • Max
  • Max
  • Moderator
  • Offline
  • Registered: 2007-05-09
  • Posts: 319

Re: 12Mic-D + DAD AX24 connected via MADI to the RME

You should make the 12Mic-D "Preferred Leader" in its clock settings. Along with "Sync to external" and MADI selected, that would usually ensure that the DAD remains Master Clock for the entire Dante network. Unless a second preferred leader comes into the network with sync to external active - I believe then you can't make sure.

  • Registered: 2023-11-03
  • Posts: 9

Re: 12Mic-D + DAD AX24 connected via MADI to the RME

Ok thanks, that's the answer I was thinking of but wasn't sure. This is my current configuration so everything is ok.