• Registered: 2024-08-18
  • Posts: 8

Topic: ADI-2 DAC FS spectrum analyser not showing pl suggest how to rectify

RME ADI-2 DAC FS spectrum analyser display not showing. Pl advise how to bring it back. The manual is not giving answers.  Only experts users can provide. Pl.   thx.

  • waedi
  • DAW Mastermind
  • Offline
  • From: Swiss Zürich
  • Registered: 2020-12-08
  • Posts: 4,522

Re: ADI-2 DAC FS spectrum analyser not showing pl suggest how to rectify

Give it a try..

Returning to Factory State
In case a total reset is desired: hold encoder 1 and the VOL button pushed while turning on the
unit. This will reset all current settings to factory default. User-stored Setups and EQ presets are
not affected. The same action is performed by loading Factory via Setup Select. Note that the
reset will be incomplete when the unit is connected to USB while performing the reset.

M1-Sequoia, Madiface Pro, Digiface USB, Babyface silver and blue
  • From: Germany
  • Registered: 2007-04-10
  • Posts: 9,770

Re: ADI-2 DAC FS spectrum analyser not showing pl suggest how to rectify

Does everything else work normally? What is the unit connected to, what's the signal source?

Regards
Daniel Fuchs
RME

RME Support's Website

  • Registered: 2023-06-30
  • Posts: 161

Re: ADI-2 DAC FS spectrum analyser not showing pl suggest how to rectify

rlrbiking wrote:

The manual is not giving answers.

It does.

Fireface UCX II + ARC USB > ADI-2 Pro FS R BE > Neumann KH 750 DSP + MA 1 > KH 120 A

5 Reply by KaiS (edited by KaiS 2024-09-06 09:36:44)

  • KaiS
  • DAW Mastermind
  • Offline
  • From: Germany
  • Registered: 2020-02-05
  • Posts: 3,523

Re: ADI-2 DAC FS spectrum analyser not showing pl suggest how to rectify

To get the main screen (analyser) back, press either Encoder 1 or 2 (the 2 knobs at the right side), until you navigated back to it.

Enc. 1 and 2 scroll up and down through the various informational screens ADI-2 offers.

KaiS's Website