Topic: Issue with Logic Pro 11.1.2 and Babyface Pro FS: PROBLEM!!!!
Hi everyone,
I’m experiencing a frustrating issue with my new RME Babyface Pro FS when using it with Logic Pro. Below is a summary of my setup and the problem:
Setup:
Audio Interface: RME Babyface Pro FS
Working DAWs: GarageBand, Reaper (no issues with these)
Problematic DAW: Logic Pro 11.1.2
Operating System: macOS Sequoia 15.2
Computer: MacBook Pro 15" (2.6 GHz Intel Core i7 6-core, 16 GB DDR4 2667 MHz RAM)
Microphones: 2 cardioid CM4 microphones connected to inputs 1 and 2 with Phantom Power enabled
RME drivers and firmware: Updated to the latest version via Fireface USB Settings
Issue:
Input Signal: The input signal in Logic appears good and has correct levels during monitoring. However, once recorded, the signal is extremely low, distorted, and noisy.
Errors: While recording, an error message appears related to sample rate and MIDI synchronization.
Clock and Sample Rate: Everything seems properly configured at 44.1 kHz in both Logic and the Babyface settings.
Other DAWs: The interface works perfectly with other DAWs like GarageBand and Reaper, with no distortion or low signal issues. It appears to be a problem specific to Logic Pro 11.1.2 and the Babyface.
Reinstallation: I’ve uninstalled and reinstalled both Logic and the RME drivers, but the issue persists.
Additional Attempts:
I’ve checked all audio settings in Logic, including buffer size and routing.
I’ve adjusted the clock settings on the interface and verified the MIDI sync settings, but no improvement.
Input levels and routing on TotalMix FX are perfect (peaking at -6 dB).
Question:
Has anyone experienced similar issues with Logic Pro 11.1.2 and the Babyface Pro FS? Are there any known solutions or specific configurations I should check to resolve the sample rate and MIDI sync issue?
Thank you very much for your help!