You are not logged in. Please login or register.
RME User Forum → FireWire & USB series → Best way to connect FF400 and octamic II
Hi!
What's the best way to connect a FF400 and a octamic II??
Adat cable and BNC for the clock??
These will be my only devices for the moment.
Should I put the FF400 as master and octamic II as slave??
Thanks!!
bump.
You seem to have the idea already. Why not try and let us know if you have a problem.
because I have to buy one cables or another...
Why not try and let us know if you have a problem.
That's a good answer to almost every question in almost every audio forum.
Just want to add that sometimes you don't have problems with devices BUT you are not connecting these devices in their best way.
Thanks
ADAT alone should be enough. Octamic as master is the simplest (working) solution.
Arjan S
ADAT alone should be enough. Octamic as master is the simplest (working) solution.
Yes, but you have to fiddle with dip switches to change sample rates. With a BNC connection, that won't be necessary. Only if you change e.g. from 48 to 96k.
Regards
Daniel Fuchs
RME
So, if (my case) I'm going to be recording only in 44.1 and 48, I put both adat and BNC, and select octamic II as master, and I won't be touching the rear panel. Right??
Thanks for your replies.
No, set FF as master, Octamic as slave.
Ok. Thanks!
RME User Forum → FireWire & USB series → Best way to connect FF400 and octamic II
Powered by PunBB, supported by Informer Technologies, Inc.