• Registered: 2008-06-27
  • Posts: 20

Topic: Recording other software's output

Hi, I have FF800 and would like to use Kontakt 4 as standalone sampler (not as plug-in) and Cubase 4 Essential as audio recorder only. I control the Kontakt 4 instruments with external sequencer (AKAI MPC4000). I can't figure out how to set up the FF's Matrix mixer & Cubase to get the audio from Kontakt into Cubase. Please help.
Thank you

  • From: Germany
  • Registered: 2007-04-10
  • Posts: 9,776

Re: Recording other software's output

The loopback feature will do the trick. See manual, "recording a subgroup".

Regards
Daniel Fuchs
RME

Regards
Daniel Fuchs
RME

RME Support's Website

  • Registered: 2008-06-17
  • Posts: 46

Re: Recording other software's output

I was having a problem doing this, even after reading the manual (RTFM)! however I did figure it out and it is possible. you can read this post for how to manage it:

http://www.rme-audio.de/forum/viewtopic.php?id=9108

it should give you what you need...

HTH

New Mac Pro, 16 GB RAM, Antelope Orion32, ProTools 11, UAD Octo, Tonelux OTB 16, and lots of toys...

climber's Website

  • Registered: 2008-06-27
  • Posts: 20

Re: Recording other software's output

Thanks both of you guys for the input! It works & was very easy to setup.