• From: Cologne, Germany
  • Registered: 2010-10-14
  • Posts: 9

Topic: UFX Problem

Hi i have strange problem:

the analog inputs 7/8 are not working! there is no signal on the meters and no signal in any recording of these channels.
Is this a hardware fault or just a dsp problem?

when i switch the samplerate, the meters of channel 1-6 rise up but not the meters of 7/8.

sad

do i have to send it back to my dealer for guarantee?

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,599

Re: UFX Problem

No signal on the meters - are you talking about TotalMix FX Inputs showing UFL instead of -108 or so (self noise)? In that case the hardware is defective and the unit needs to be sent back.

Regards
Matthias Carstens
RME

MC's Website

  • From: Cologne, Germany
  • Registered: 2010-10-14
  • Posts: 9

Re: UFX Problem

Yes it shows Ufl instead of a Number. sad
I will send it back Tomorrow.

  • Registered: 2011-10-02
  • Posts: 1

Re: UFX Problem

I have the same thing, but it occurs on inputs 3 and 4.  Also, I don't see any thing spike on channels 11 and 12, but they are registering self noise.
So the only resolution is to send the unit back?