1 Topic by mehmethan (edited by mehmethan 2010-11-26 12:32:54)

  • Registered: 2007-09-03
  • Posts: 2

Topic: Routing line inputs to line outputs, is there any AD/DA conversion

Hi,
When I route a line input to a line output on Totalmix FX is there AD/DA conversion during this process ? or is it  pure analog signal routing ?

(example : input 1-2 routed to output 5-6  on totalmix fx  (no change on volume,pan,eq,reverb..etc.)



(I am planning to use Rme analog inputs & outputs as a regular patcbay)

  • From: Germany
  • Registered: 2007-04-10
  • Posts: 9,776

Re: Routing line inputs to line outputs, is there any AD/DA conversion

mehmethan wrote:

or is it  pure analog signal routing?

If you meant "digital", the answer is yes...


Regards
Daniel Fuchs
RME

Regards
Daniel Fuchs
RME

RME Support's Website

  • From: Gothenburg, Sweden
  • Registered: 2007-05-01
  • Posts: 441

Re: Routing line inputs to line outputs, is there any AD/DA conversion

Hi,

Routing Analog with AD/DA yes conversion
but if you mean TotalMix inside (loopback)
then no AD/DA involved

I have not studied the new TotalMix FX or how it works
old FF 800 user

regards S-EH

  • Registered: 2007-09-03
  • Posts: 2

Re: Routing line inputs to line outputs, is there any AD/DA conversion

Thanks for the replies.
So What I understand from your replies is :

1 ) Analog input -> AD -> Digital  -> DA -> Analog Output   (total mix routing)
2 ) Digital data of an output -->  digital data of an input (loopback)

  • From: Germany
  • Registered: 2007-04-10
  • Posts: 9,776

Re: Routing line inputs to line outputs, is there any AD/DA conversion

Precisely.

Regards
Daniel Fuchs
RME

Regards
Daniel Fuchs
RME

RME Support's Website