• Registered: 2010-12-30
  • Posts: 2

Topic: FF 800 routing help

Hi there,

I'm new about ff800 and total mix.
What I need is copy (routing) output 1-2 to output 5-6 to get the exact signal on both stereo output.

Thanks in advance.

Lorenzo

  • Registered: 2008-12-03
  • Posts: 182

Re: FF 800 routing help

You don't need Totalmix to do that, insert some sends, set up a extra bus in your DAW and route that bus to whatever output:-)

-----------------------

Various ADK computers :-)
  • Registered: 2010-02-22
  • Posts: 29

Re: FF 800 routing help

Assuming that you're trying to get 1-2 an 5-6 FF800 HARDWARE outputs to work with the same signal, just select 5-6 HARDWARE outputs in Totalmix(at the bottom row) and then raise SOFTWARE output channels faders(middle row) that are feeding your 1-2 hardware outputs.

Simples as that!

hope this help.

see ya

  • Registered: 2010-12-30
  • Posts: 2

Re: FF 800 routing help

Yes, actually i was trying to get 1-2 an 5-6 FF800 Hardware. And it works!
Thanks a lot guys.

L