• Registered: 2010-07-14
  • Posts: 14

Topic: Midi problem/bug

Hi

I have an issue with totalmix and the use of MIDI. The problem is that when sample rate is changed between 48kHz and 96kHz (losing the last 8 channels in the mixer), the 8 channels under MIDI control shift.

I am using windows volume relay (posted in the tips and tricks section) that uses MIDI to link the windows volume to the mixer volume.

But when I change to 96kHz, I can no longer control the volume, as the channels under control have shifted.

I hope this can be fixed in totalmix soon

Brad

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,604

Re: Midi problem/bug

As channels do vanish in that mode (ADAT) how can the block NOT shift? Or did I misunderstood?

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2010-07-14
  • Posts: 14

Re: Midi problem/bug

It could not shift if it was associated with a channel, rather than a position in the mixer.

I need it associated with a channel

4 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,604

Re: Midi problem/bug

Which is not possible, as you can not run out of the last 8-channel block (like 2 channel remain, 6 are invisible..). Nevertheless I will check if there is way to work around this.

Regards
Matthias Carstens
RME

MC's Website