• Registered: 2010-11-13
  • Posts: 5

Topic: connection with cubase...

Hi,

i ve got a problem with getting the signal from my hammerfall II into cubase.
I cant record!!!

In the HDSP mixer are three rows.
In the first i have a signal in channel 8 analog.
In the second i have no signal, because i dont use the outputs.
In the third row i have a output on the phones or on SP.L or SP.R. I can switch there.

What i ve done wrong???

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 24,875

Re: connection with cubase...

You didn't read the Cubase manual. Select the RME ASIO driver and configure the I/Os in Cubase.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2010-11-13
  • Posts: 5

Re: connection with cubase...

Hi MC,

thank you, but id hosted the driver and the Inputs and Outputs in "VST-Geräte/gear".
If there is no Input and i click recording, there is a thin line for the level-meter. If i record with the RME input, there is a thicker line on the level-meter.

I dont know where the mistake is.

  • Registered: 2010-11-13
  • Posts: 5

Re: connection with cubase...

so id seen that is not the problem.
I got my Inputs right installed and i had something recorded. But unfortunatly i cant hear anything. I like this signal on my headphones with what im playing, that i have a playback on my phones.