I just got my new HDSPe AIO (driver 3.08.5) on a clean install of windows 7 64bit with Cubase. I am on autosync spdif optical in/out to my Lucid AD/DA converters. In the device manager in Cubase my latencies are as follows. Low latencies are double what my old Hammerfall 9632 are.

AIO Buffer Setting             Cubase device manager
32                                      1.604 in
                                         2.313 out
                This is more than my old hammerfall 9632 at a 64buffer. Weird.

64                                      2.271 in
                                         2.979 out

128                                    3.604
                                         4.313

256                                    6.271
                                         6.979

512                                   11.604
                                        12.313
                     Here at 512 they start to be more true to the actual ms setting on the RME with the extra 32 on the out side

1024                                 22.271     
                                       22.979
                      Here they are actually lower than the RME ms setting. Very confusing.

2048                                43.604
                                      44.313

So what's happening at the lower latencies up to through to 256? These are at 48k. Is this right? Am I missing something? At a 32 buffer setting shouldn't I be showing 0.7ms in and 1.4 out?
I also tried this on another hard drive with Windows 32bit installed so I could compare to my old Hammerfall 9632. The old card read out the same ms in Cubase as shown on the card itself. This is what I am used to seeing. So at a 64 buffer setting Cubase read 1.5 in and out. The AIO was the same as above. Doubled! What's going on. Help )
Thanks