• Baros
  • Baros
  • ADAT user
  • Offline
  • Registered: 2011-01-14
  • Posts: 19

Topic: ADM pans channel to right

Using Asio Direct Monitoring in Cubase 5:
one mono input bus (source AN1)
TotalMixFX setting for AN 1/2: not stereo, each mono channel panned to center.

When Monitor is activated from DAW's track everything's ok (input is routed to both channels of the stereo output);
when deactivating Monitor, routing dissapears (volume drops to 0) but the panning for Input AN1 gets stuck totally right (R100).

I have no other DAW to test if this is a Cubase issue or a flaw in TotalMixFX.

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,599

Re: ADM pans channel to right

Cubase issue. It definitely sends what you see in TM FX. Apart from that its not a big problem. Whenever you engage the monitoring it (Cubase) will set the pan correctly again.

Regards
Matthias Carstens
RME

MC's Website

  • Baros
  • Baros
  • ADAT user
  • Offline
  • Registered: 2011-01-14
  • Posts: 19

Re: ADM pans channel to right

Thank you Matthias!