• Registered: 2011-06-14
  • Posts: 2

Topic: Multi-Client Setup

I have the HDSPe AIO card which I am using the Analog 1/2 outputs in my DAW with ASIO for playback.

I am trying to simultaneously send this audio output from my DAW also into the Flash Media Encoder but I get no signal.

Does anyone know basically how I could simultaneously send this playback output from the DAW into another program such as the Flash Media encoder? I am using Windows 7 64bit.

I am trying to broadcast a live Webcam music show.

Thank you for any advice.

  • isaac
  • isaac
  • S/Mux specialist
  • Offline
  • From: Auckland New Zealand
  • Registered: 2007-05-01
  • Posts: 339

Re: Multi-Client Setup

Loopback. Explained more in the manual. You press Ctrl and left mouse button on a selected output. I suggest you use another output rather than your main outs, then you can easily adjust the level. Then in your other program select the input you looped back.

Isaac P

  • isaac
  • isaac
  • S/Mux specialist
  • Offline
  • From: Auckland New Zealand
  • Registered: 2007-05-01
  • Posts: 339

Re: Multi-Client Setup

Or use the latest driver it has multi-client ability. I would tend towards loopback though as it gives you more versatility to change your listening and sent levels independently.

Isaac P

  • Registered: 2011-06-14
  • Posts: 2

Re: Multi-Client Setup

Thank you very much for the info, I've now enabled Loopback on 2 seperate channels from my main outs as you suggested and it works fine.