• Registered: 2012-12-27
  • Posts: 28

Topic: Can you set up and DURecord 'stand alone?

Can track record selection and arming not be done for DuRecording from the front panel?

  • From: Germany
  • Registered: 2007-04-10
  • Posts: 9,751

Re: Can you set up and DURecord 'stand alone?

Yes, of course... All explained in the manual.

Regards
Daniel Fuchs
RME

Regards
Daniel Fuchs
RME

RME Support's Website

  • Registered: 2011-05-04
  • Posts: 249

Re: Can you set up and DURecord 'stand alone?

That's right...and additional comment is, be patient and spend at least an hour with the front panel screen and these encoders (knob/button) going up/down, right/left. When I take UFX to location recording (stand alone, no laptop), I usually 'practice' a night before how I operate the encoders so I that I can set up parameters as quickly as possible on site. It's tough to browse all the functions of Total Mix FX in the small screen, but you'll get it eventually!

  • Registered: 2012-12-27
  • Posts: 28

Re: Can you set up and DURecord 'stand alone?

Ok that is good news then as that's one of the primary reasons I'm looking at the unit.
I hit the manual again, Rec/Stop/Playback, number of ch's selected are mentioned, "all setting directly available at the unit' -- Track selection then is in one of the display screens just not mentioned ?