1 Topic by explodingPSYCH (edited by explodingPSYCH 2021-05-20 03:33:44)

  • Registered: 2017-12-26
  • Posts: 49

Topic: CCs for Solo/Mute on Software Playback Channels

Is there a CC (or MIDI note) I can use to control the Mute/Solo function of specific channels in the software playback section of Totalmix (like ADAT1, etc)?

I already use the X-Touch and X-Touch Mini to control the input channels faders/panning and for selecting the Submix output channels. Now I wanting to trigger the mute and solo button of my software playback channels for my metronome and DAW respectively.

I know are controllable with the control surface (banking down to them, etc) but I have a LOT of channels and it won't be worth it to bank to them to do this (would be faster to just pull up the window).

Trying to get as much done with my controllers as possible and I have the free buttons on my X-Touch MINI.

I'm using:
UFX+(master)
UFX(ADAT)
M32AD(MADI)
M32DA(MADI).
(The software playback channels I want to map would be the UFX+'s ADAT software playback.)

  • Registered: 2017-12-26
  • Posts: 49

Re: CCs for Solo/Mute on Software Playback Channels

Bump.

3 Reply by MathieuC (edited by MathieuC 2021-05-29 23:42:16)

  • Registered: 2021-05-28
  • Posts: 1

Re: CCs for Solo/Mute on Software Playback Channels

I'm also very interestd in this answer as I'm struggling with TotalMix MIDI information.

I've alredy read the documentation, I'm aware about the note octave misunderstood, and I've already made a tons o research on this forum and found only 2 intersting posts :

https://forum.rme-audio.de/viewtopic.php?id=31305
https://www.forum.rme-audio.de/viewtopic.php?id=24437,

I also have to mention that I can"t get the xtouch mini to get feedback informations from totalmix while I'm starting.